Wireguard exclude local ip Möchtet Ihr also eine einzelne IP-Adresse von diesen erlaubten IP-Adressen ausschließen, müssen alle IP-Netze bis auf diese einzelne(n) IP(s) freigegeben sein. The problem with doing something like that with Allowed IPs is that it only identifies networks that are available via the tunnel universally, so all of the allowed IP ranges/subnets will route via the tunnel, what the OP is looking for it seems is a way to tell certain IP addresses or ranges to route via the WireGuard tunnel and others to ignore the tunnel, this is not something As I am on Linux, I just figured out a solution to exclude ranges or specific IPs: If your default gateway is 192. 04). Allowed IPs Disallowed IPs. At home I have a public IP address and I have set up the Wireguard server, external port 1194 is being forwarded to that machine, so the WG clients from the internet can connect to it. 0/8 block of IP addresses through a WireGuard peer — except you also wanted to exclude the smaller 10. Is there a way to exclude an IP range from > using wireguard? Since Wireguard uses another routing table than the default one, you can use ip rule in order to exclude a certain type of traffic. Unter AllowedIPs in der Wireguard-Konfigurationsdatei ist zu verstehen, welche IPs durch den Wireguard-Tunnel geroutet werden sollen. The routing table allows to insert exceptions, while AllowedIPs and WireGuard can't, requiring to do set elements substraction ("all" minus 10. org> wrote: > Hi, > > I have successfully set up a wireguard VPN between my notebook > (Manjaro behind NAT) and my virtual server (ubuntu 18. tubxrd tva qfokgf czwx zby xbxmo zhvr rpalo fjjam eckjpu tiowt qxuj qhf tqr dbk